Larry H. Miller Chrysler Dodge Jeep Ram Avondale

Jeep Wrangler Tire Pressure Light

Jeep Wrangler Tire Pressure Light service at Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale, AZ

Frequently asked questions
2027 Jeep Wrangler Rubicon shown

On a Jeep Wrangler, the tire pressure light means one or more monitored tires is at least 25 percent below the pressure shown on the placard inside the driver’s door jamb, or that the tire pressure monitoring system has a fault. The warning symbol looks like a horseshoe-shaped tire outline with an exclamation point inside. A steady light calls for tire pressure to be checked and set at the next stop, while a light that flashes for about a minute at startup and then remains on points to a monitoring-system issue. Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale, AZ, checks both tire pressure and sensor operation. The visit can identify whether the Wrangler needs air, a tire inspection, or sensor attention.

What the tire pressure light means on a Jeep Wrangler

The tire pressure warning is a horseshoe-shaped tire outline with an exclamation point inside. When it stays steadily illuminated, one or more monitored tires is at least 25 percent below the placard pressure. This can happen after a cold night because tire pressure drops about one psi for every ten degrees. Even when a tire appears full, its pressure should be measured against the driver’s-door placard.

If the light flashes for about a minute after startup and then stays illuminated, the tire pressure monitoring system has a fault, usually involving a sensor whose battery has run down. An underinflated tire wears faster and runs hotter, so the pressure should be set at the next stop. Larry H. Miller Chrysler Dodge Jeep Ram Avondale can check the tires and monitoring system to help distinguish low pressure from a sensor concern.

What the diagnosis covers at Larry H. Miller Chrysler Dodge Jeep Ram Avondale

The tire pressure light service includes a pressure check of every monitored tire against the placard on the driver’s door jamb. Each tire pressure sensor’s signal and battery status are also scanned. The inspection includes looking for punctures and leaking valve stems, followed by a system relearn after any sensor or tire work.

This process separates a tire that needs air or a repair from a sensor that needs replacing. Drivers who notice the light after a temperature change, see it remain on despite fully inflated-looking tires, or observe the startup flashing pattern can schedule service with Larry H. Miller Chrysler Dodge Jeep Ram Avondale.

Recalls on the Jeep Wrangler

NHTSA campaign 14V632000 covers the 2014 Jeep Wrangler. A software error may prevent the Tire Pressure Monitoring System from learning individual sensor locations, allowing the low-pressure warning to illuminate and potentially masking an actual low-pressure condition. That condition could result in tire failure and increase the risk of a crash. Larry H. Miller Chrysler Dodge Jeep Ram Avondale checks open recalls by VIN and performs a franchised-dealer recall remedy at no charge to the owner.

Booking at Larry H. Miller Chrysler Dodge Jeep Ram Avondale

A visit includes checking every monitored tire’s pressure, scanning each sensor’s signal and battery status, inspecting for punctures and leaking valve stems, and relearning the system after tire or sensor work. Drivers can schedule service online or contact Larry H. Miller Chrysler Dodge Jeep Ram Avondale directly at 480-207-2126.

The dealership is located at 10101 West Papago Freeway, Avondale, AZ 85323.

Frequently Asked Questions

5 common questions answered

What does the tire pressure light look like on a Jeep Wrangler?It looks like a horseshoe-shaped tire outline with an exclamation point inside.

A steady light means one or more monitored tires is at least 25 percent below the driver’s-door placard pressure. A flashing light at startup that then remains on indicates a tire pressure monitoring system fault.

Why is the tire pressure light on when my tires look full?The tires may still be below the placard pressure even if they look fully inflated, or the monitoring system may have a fault.

Pressure can drop about one psi for every ten degrees after a cold night. Larry H. Miller Chrysler Dodge Jeep Ram Avondale checks actual pressure, sensor signals, battery status, punctures, and leaking valve stems.

What does a flashing tire pressure light mean?A light that flashes for about a minute at startup and then stays on means the tire pressure monitoring system has a fault.

The service includes scanning each sensor’s signal and battery status. It can help separate a sensor concern from a tire that needs air or repair.

Can I keep driving with the tire pressure light on?Pressure should be set at the next stop because an underinflated tire wears faster and runs hotter.

A steady light indicates that one or more tires is at least 25 percent below the placard pressure. If the light flashes and remains on, the monitoring system needs attention, so the tires and sensors should be checked.

How do I book tire pressure light service in Avondale?Drivers can schedule service with Larry H. Miller Chrysler Dodge Jeep Ram Avondale online.

The dealership checks every monitored tire and sensor, inspects for punctures and leaking valve stems, and can relearn the system after tire or sensor work. The dealership is at 10101 West Papago Freeway, Avondale, AZ 85323, and can be reached at 480-207-2126.