2025 Ram ProMaster EV Step Van Alignment: Specs & Service

Rather than paying for an alignment automatically, consider service when the van pulls on a flat road, the steering wheel is off center, or tire tread wears unevenly. An alignment is also appropriate after suspension work or a major pothole impact. Measuring the current angles shows whether adjustment is needed.

• No manufacturer interval is stated
• Service after suspension work or major impact
• Measurement confirms whether adjustment is needed

Wheels that are out of alignment scrub the tires as the vehicle rolls. On an electric commercial van such as the 2025 Ram ProMaster EV Step Van, these symptoms warrant an inspection of the tires, steering, and suspension before adjustment.

• Vehicle pulls on a flat road
• Steering wheel sits off center
• Tread wears unevenly across an edge

The technician checks the tires, steering, and suspension for wear that could prevent the alignment from holding. Where the suspension allows, angles are adjusted back to the manufacturer's specification. Booking service gets the current angles measured against factory specification so you can learn whether adjustment is needed before paying for one.

• Camber, caster, and toe measurement
• Adjustment where the suspension allows
• Inspection for wear affecting alignment

During service, the tires, steering, and suspension are inspected before alignment work. Components such as tie rods, ball joints, or struts may require attention if wear is present. The inspection helps identify whether the angles can be corrected or whether a mechanical concern needs to be addressed first.

• Steering components are inspected for wear
• Suspension condition is checked before adjustment
• Alignment need is confirmed by measured angles

For the 2025 Ram ProMaster EV Step Van, measurement is most useful after symptoms, suspension work, or a major pothole impact. A straight-tracking vehicle can still receive a tire, steering, and suspension inspection to identify conditions that could affect alignment.

• Check for even tire wear
• Watch for an off-center steering wheel
• Measure angles after significant impact

The service measures all four wheel angles and checks related tire, steering, and suspension components. Use the schedule service page to request an appointment, or review service specials before booking.

• Located in Avondale, Arizona
• Four-wheel angle measurement
• Service phone: 480-207-2126

The technician measures camber, caster, and toe on all four wheels. Where the suspension allows adjustment, the angles are returned to the manufacturer's specification. This process is designed to address tire scrubbing, pulling, and a steering wheel that is not centered while driving straight.

Booking service gets the current angles measured against factory specification, helping you learn whether an adjustment is needed before paying for one. Schedule through the service department or call 480-207-2126 for Larry H. Miller Chrysler Dodge Jeep Ram Avondale.

Technicians measure all four wheels and compare the readings with the manufacturer's specifications. Adjustment is performed where the suspension allows. The inspection also looks for tire, steering, and suspension wear that could push the alignment out of specification or prevent it from holding.

Because the correct result depends on measured vehicle angles, service should begin with verification rather than an assumed adjustment. Bring your 2025 Ram ProMaster EV Step Van to Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale for a factory-spec alignment — schedule service.

Road impacts can change wheel angles, while tire, steering, or suspension wear can keep an alignment from remaining within specification. The service visit measures the current camber, caster, and toe values on all four wheels and checks the related components before adjustment.

To discuss alignment service for the 2025 Ram ProMaster EV Step Van, call 480-207-2126 or schedule an appointment with Larry H. Miller Chrysler Dodge Jeep Ram Avondale.