2025 Ram 1500 Alignment: Specs & Service

An alignment is typically considered after suspension work, a major pothole impact, or when handling and tire-wear symptoms appear. In Avondale, an inspection can measure the current angles instead of assuming an adjustment is needed. This approach helps identify whether the truck is within factory specification.

• Check alignment after a significant road impact.
• Have the angles checked after suspension repairs.
• Address pulling, off-center steering, or uneven tread wear.

A 2025 Ram 1500 may also develop vibration at speed when alignment, tire, wheel, or suspension concerns overlap. Larry H. Miller Chrysler Dodge Jeep Ram Avondale inspects the tires, steering, and suspension components that can affect alignment. Measuring all four wheels helps clarify whether an adjustment is appropriate.

• Vehicle pulls on a flat road.
• Steering wheel is not centered while driving straight.
• One edge of a tire wears faster than the other.

The process begins with an inspection of tires, steering, and suspension components for wear that could hold an alignment out of specification. The technician then compares the current wheel angles with factory specifications before discussing any adjustment. Booking gives you measured information before paying for an adjustment.

• Camber, caster, and toe measurement.
• Inspection for wear affecting alignment.
• Adjustment toward manufacturer specification where possible.

An alignment inspection should include the steering and suspension components that control wheel position. If a part has excessive wear, adjusting the angles alone may not resolve the concern for long. The service team can explain whether a component inspection points to an alignment adjustment or additional repair.

• Inspect tie rods for wear or looseness.
• Check ball joints and suspension components.
• Review tire wear before recommending adjustment.

It becomes more relevant after a major pothole impact, suspension work, or a change in steering feel. Measuring the current angles can show whether the truck remains within factory specification. That information helps avoid paying for an adjustment that is not needed.

• Consider measurement after a significant impact.
• Check alignment after suspension component replacement.
• Use tread wear and steering feel as warning signs.

The service covers measurement of camber, caster, and toe on all four wheels, followed by adjustment where the suspension allows. The team also checks tires, steering, and suspension components for wear that can affect alignment. You can schedule service before visiting.

• Location: 10101 West Papago Freeway, Avondale, AZ 85323.
• Service includes wheel-angle measurement.
• Call 480-207-2126 for assistance.

Inspection matters before adjustment because worn tires, steering parts, or suspension components can hold an alignment out of specification. A truck that pulls, has an off-center steering wheel, or develops one-edge tire wear may need more than an angle correction. Measuring the current condition helps separate an alignment issue from component wear.

With rear-wheel-drive and four-wheel-drive configurations available across the model, the correct service begins with the specific vehicle's measured angles. The 2025 Ram 1500 is equipped with an automatic eight-speed transmission and six-cylinder engine choices across the model range. Bring your 2025 Ram 1500 to Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale for a factory-spec alignment — schedule service.

Larry H. Miller Chrysler Dodge Jeep Ram Avondale serves drivers at 10101 West Papago Freeway, Avondale, AZ 85323. The alignment process includes measurement of camber, caster, and toe on all four wheels, along with inspection of tires, steering, and suspension components. This gives the driver a vehicle-specific assessment rather than assuming every tire-wear concern requires an alignment.

For directions or appointment help, call 480-207-2126. You can also schedule service online for your 2025 Ram 1500 and discuss the symptoms you have noticed before the inspection.