2024 Jeep Wrangler Alignment: Specs & Service

The service begins with measuring the current wheel angles against the manufacturer's specifications, so you can learn whether an adjustment is needed before paying for one. The inspection covers all four wheels and looks for tire, steering, and suspension wear that could affect alignment results.

• Camber, caster, and toe measurement
• Suspension and steering component inspection
• Adjustment where the suspension allows

An alignment check is appropriate when the Wrangler pulls on a flat road, the steering wheel is off center, or one edge of a tire wears faster than the other. It is also useful after suspension work or a significant impact. Measuring the angles first helps identify whether adjustment is necessary.

• Check alignment after noticeable road impact
• Inspect uneven tire wear promptly
• Compare readings with factory specifications

These symptoms can indicate that the wheels are not tracking within specification. A proper inspection also checks tires, steering, and suspension components before adjustment. Measuring the current angles confirms whether an alignment can address the concern.

• Vehicle pulls on a flat road
• Steering wheel sits off center while driving straight
• Tire tread wears faster on one edge

The technician inspects the tires, steering, and suspension for wear that could hold an alignment out of specification. This approach identifies conditions that may affect tire wear or cause the steering to pull rather than treating wheel angles alone.

• Measurement of camber, caster, and toe
• Inspection for worn tires, steering, and suspension components
• Adjustment back to manufacturer specification where possible

Worn tie rods, ball joints, or struts can affect alignment results and may require attention before adjustment. Larry H. Miller Chrysler Dodge Jeep Ram Avondale inspects related components and explains what is found. The alignment measurement helps separate an angle adjustment from a component concern.

• Inspect tie rods, ball joints, and struts
• Check tires and steering components for wear
• Review whether the suspension can hold specification

If the Wrangler tracks straight and its tires wear evenly, an alignment may not require adjustment at every service visit. Checking the angles is especially useful after a major impact, suspension work, or a change in tire wear. The inspection provides a vehicle-specific result rather than relying only on symptoms.

• Measure current angles against factory specification
• Look for uneven tread wear
• Inspect steering and suspension condition

Larry H. Miller Chrysler Dodge Jeep Ram Avondale is located at 10101 West Papago Freeway, Avondale, AZ 85323. The team inspects tires, steering, and suspension components that could affect alignment results. If your Wrangler pulls to one side or the steering wheel is not centered on a straight road, contact the service department to arrange an inspection and measurement.

Schedule service with Larry H. Miller Chrysler Dodge Jeep Ram Avondale or call 480-207-2126.

Where adjustment is possible, the angles are brought back toward factory specification. The inspection matters because worn tires, steering parts, or suspension components can cause an alignment to move out of specification again. Measuring first helps explain whether the Wrangler needs an adjustment or further component attention.

To begin the process, schedule service with Larry H. Miller Chrysler Dodge Jeep Ram Avondale. You can also call 480-207-2126 to discuss an alignment concern.

Alignment symptoms can include pulling to one side on a flat road, an off-center steering wheel, or faster tread wear along one edge. Because the Wrangler uses a V6 engine producing 285 horsepower and 260 lb-ft of torque, maintaining predictable tire contact supports confident control during everyday driving and towing up to 2,000 pounds.

Bring your 2024 Jeep Wrangler to Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale for a factory-spec alignment — schedule service.