Larry H. Miller Chrysler Dodge Jeep Ram Avondale

2010 Dodge Charger Oil Filter

Dodge Charger Oil Filter service at Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale, AZ

Frequently asked questions

The 2010 Dodge Charger is a rear-wheel-drive or all-wheel-drive sedan offered with V6 and V8 engines ranging from 2.7 to 6.1 liters and 6 to 8 cylinders. At Larry H. Miller Chrysler Dodge Jeep Ram Avondale in Avondale, AZ, an oil filter service pairs a correctly matched filter with fresh engine oil. The filter captures debris carried by the oil, helping maintain cleaner oil circulation as the engine operates. A new filter, sealing washer or gasket where applicable, and a leak check after the engine runs are included. Booking this service is a practical way to address a loaded filter and keep routine lubrication work together for your 2010 Dodge Charger.

What an oil filter replacement on a 2010 Dodge Charger involves

An oil filter replacement for the 2010 Dodge Charger begins with a filter matched to the engine actually fitted to the sedan. That matters because this model was offered with different engine configurations, and the correct filter must suit the engine's requirements rather than simply fit the vehicle's exterior dimensions. During the service, the filter is replaced alongside the oil so the newly installed lubricant does not immediately pass through an already loaded filter.

Where the engine uses one, the service also includes a new drain plug gasket or washer. This helps renew the sealing surface used when the drain plug is refitted. After the engine has been run, the filter seal is checked for leaks. That final check helps confirm that the filter and related sealing points remain secure after oil begins circulating. To have the filter matched to your Charger and replaced with the oil, schedule service at Larry H. Miller Chrysler Dodge Jeep Ram Avondale.

Why the filter matters on a 2010 Dodge Charger

The 2010 Dodge Charger uses engines ranging from 2.7 to 6.1 liters, with 6 to 8 cylinders across its trims. As engine oil moves through a 2.7-liter V6, a 6.1-liter V8, or another configuration in that range, it carries away particles and other debris. The oil filter holds that debris so the oil can continue circulating through the engine with filtration in place.

As the filter loads, its bypass valve opens. That does not stop the engine from getting oil; it means the engine can receive oil that is no longer being filtered. Unfiltered oil circulation is a quiet form of protection loss, which is why replacing the filter with the oil makes sense rather than stretching one filter across two changes. The replacement filter is matched to the engine fitted to your Charger, supporting the lubrication service without naming a part that may not apply to every engine.

Oil and filter service at Larry H. Miller Chrysler Dodge Jeep Ram Avondale

At Larry H. Miller Chrysler Dodge Jeep Ram Avondale, an oil filter service for the 2010 Dodge Charger covers the filter matched to the engine, a new drain plug gasket or washer where the engine uses one, and a check for leaks after the engine has run. The work addresses the filter's role in holding debris carried by engine oil and replaces it alongside the oil, rather than leaving a loaded filter in service.

The manufacturer's maintenance schedule for this model year does not establish an interval stated here, so the appropriate timing depends on that schedule, the vehicle's service history, and inspection findings. To arrange service in Avondale, visit 10101 West Papago Freeway, Avondale, AZ 85323, or call 480-207-2126. You can also schedule appointment online.

Frequently Asked Questions

6 common questions answered

Is the oil filter replaced every time a 2010 Dodge Charger has its oil changed?Yes, this oil and filter service replaces the filter alongside the oil.

A filter holds debris collected from the oil as it circulates through the engine. Replacing both together prevents fresh oil from immediately passing through a filter that has already loaded with debris. The correct timing for the service follows the manufacturer's maintenance schedule and the vehicle's service history.

  • Filter matched to the engine fitted to the Charger
  • New drain plug gasket or washer where applicable
  • Leak check after the engine has run
What is included in an oil filter replacement on a 2010 Dodge Charger?The service includes a matched filter, a new drain plug gasket or washer where applicable, and a post-service leak check.

The filter is selected for the engine actually fitted to the vehicle. After the filter and oil work is completed, the engine is run so the filter seal can be checked for leaks. This keeps the filter replacement and related sealing work together.

  • Engine-specific oil filter
  • New drain plug sealing component where used
  • Inspection of the filter seal after running the engine
What happens if the oil filter on a 2010 Dodge Charger is not replaced?A loaded filter can open its bypass valve, allowing oil to circulate without filtration.

The engine still receives oil, but it may no longer receive filtered oil. That distinction matters because the filter's job is to hold debris carried away by the oil. Inspection, service history, and the manufacturer's maintenance schedule help determine when replacement is appropriate.

  • Debris remains captured only until the filter loads
  • The bypass valve can allow unfiltered oil circulation
  • An oil-pressure warning or noisier engine may draw attention to a concern
Does a 2010 Dodge Charger need a specific oil filter?Yes, the filter is matched to the engine, and filters are not interchangeable across engines.

The 2010 Dodge Charger was offered with engines ranging from 2.7 to 6.1 liters and from 6 to 8 cylinders. The engine fitted to the vehicle determines the appropriate filter, so the service begins by matching the filter to that engine. A part number or filter specification is not needed to explain that fitment decision.

  • Engine displacement range: 2.7 to 6.1 liters
  • Engine configuration range: 6 to 8 cylinders
  • Filter selection based on the engine actually fitted
Can the oil be changed on a 2010 Dodge Charger without changing the filter?The oil can be changed separately, but this service replaces the filter with the oil.

Using a new filter with fresh oil avoids carrying a loaded filter into another service cycle. Once a filter loads, its bypass valve can allow unfiltered oil to circulate, so the filter should not be treated as incidental to the oil service. The manufacturer's schedule and the vehicle's service history determine the broader maintenance timing.

  • Fresh oil is paired with a correctly matched filter
  • Debris remains captured by a new filter
  • Filter sealing surfaces are renewed where applicable
How do I book an oil and filter service at Larry H. Miller Chrysler Dodge Jeep Ram Avondale?Book online through the service page or call Larry H. Miller Chrysler Dodge Jeep Ram Avondale at 480-207-2126.

The store is located at 10101 West Papago Freeway, Avondale, AZ 85323. Booking lets the service team match the filter to the engine fitted to your 2010 Dodge Charger and replace it alongside the oil. The appointment includes the filter, applicable drain plug sealing component, and a leak check after the engine runs.